Stages of building a barn on an uneven site
One of the important outbuildings is a barn. For its construction, it is necessary to decide on the site, structure and materials. Not always the building plot will be flat. But, despite some difficulties, a good shed can be built on an uneven section. Construction of a shed should be divided into stages. Stage No. 1. Foundation. For commercial buildings, most often use a strip foundation. It is simple to build, functional and relatively cheap. 1. At the initial stage, you should mark the site and dig a trench along the contour of the shed. The depth and width of the trench will depend on the characteristics of the site and the climate.2. Then in the trench you need to make a rubble cushion (to distribute the load on the foundation). To do this, sand is poured at the bottom of the trench. Then make a layer of broken bricks.Void between the bricks again wake up with sand and shed water. When the water in the trench stops being absorbed, then it will be clear that the bottle is ready.3. Next, formwork must be installed. To make it, you need to knock down wooden boards and use a stapler to wrap them with a film. To install the formwork along the contour boundaries of the future structure. Since the plot is uneven, the formwork will consist of several levels.4. Reinforcement is required inside the formwork. To do this, in each of the steps of the formwork we place the reinforcement and link it together.5. Then you can proceed to concreting. To do this, prepare a solution. Fill each formwork separately. We set a new level of formwork and continue to concrete. When the concrete hardens, the formwork can be removed.6. The final effect in the manufacture of the foundation will be its alignment using brickwork.To do this, we calculate the number of bricks required for work, and alternately align each of the steps of the foundation.Stage № 2. Construction of walls. Walls for a shed will be made from a cinder block. 1. To begin it is necessary to level out roughnesses on the foundation, and then to lay a waterproofing.2. Now we start laying walls. We produce the masonry using a cord-pier. Blocks are seated to the level of the cord-pier. We make laying to the desired level.Stage # 3. Armpoos. To protect the building from external factors of influence, it is necessary to strengthen the structure using a reinforced belt. 1. For the construction of the armpoyas we make assembling of shields from the shawl and twist them together. Install ready-made billboards on the wall.2. Then you need to put the reinforcement inside the shields and link it.3. Fixing the shields.4. We produce the filling of the reinforced belt with a solution of cement and slag.5 After the belt has stiffened, it is necessary to remove the shields.Stage 4. Roof. Erection of the roof is time consuming and responsible stage in the work. It is necessary to prepare materials and accessories for ease of operation. 1.Before the roof perimeter it is necessary to expand the bars under the beams.2. Under each beam it is necessary to lay waterproofing.3. Fix the boards with boards.4.We produce the erection of the truss system. To do this, you need beams of 50 * 100 mm.Then we fix the parallel bars between each other using a batten.5.Set up the gables.6. In conclusion, it is necessary to cover the roofing with roofing felt. We also install the door and windows.Stage No. 5. The blind area. At the end of all the work we produce the blind area. It will protect the building from moisture. 1. To make a blind area, it is necessary to prepare a site. We make a small deepening, install the formwork and fill it with cement mortar.2.The formwork can be removed in a few days.In this form, the barn can be used for your needs.